Hello!
I'm trying to set up a Multicast VPN and encountered the following problem:
Given a single-protocol IPv4-only VRF I have the possibility to configure this:
PE1(config)#ip vrf VRF123
PE1(config-vrf)#mdt default 239.232.0.0
When I upgrade to a Multiprotocol VRF there is no way of using "ip vrf" command because it says:
PE2(config)#ip vrf VRF123
% Use 'vrf definition VRF123' command
PE2(config)#
That's no big deal but with "vrf definition VRF123" I can not specify any mdt command:
PE2(config-vrf)#?
VPN Routing/Forwarding instance configuration commands:
address-family Enter Address Family command mode
default Set a command to its defaults
description VRF specific description
exit Exit from VRF configuration mode
no Negate a command or set its defaults
rd Specify Route Distinguisher
route-target Specify Target VPN Extended Communities
vpn Configure VPN ID as specified in rfc2685
Does anybody know if I can find it somewhere else for a Multiprotocol VRF or if I don't need it any longer (which I doubt) or if there is any workaround?
By the way I'm running this: Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVENTERPRISEK9-M), Version 12.2(33)SRD4, RELEASE SOFTWARE (fc2)
Thank you in advance!
Nik