Dear community,
is it possible to create MACsec peering via VPLS network ?
Please find attached drawing.
https://drive.google.com/drive/folders/1zDvfm09pzZBNfwxWuWUOrgzA9Yj0gce5?usp=sharing
I've got MP-BGP peering with this config but without CTS enabled on port Gi1/0/48.
With MACsec enabled, BGP doesn't work.
Advice me please.
Interface CTS output:
#show cts interface gigabitEthernet 1/0/48
Global Dot1x feature is Disabled
Interface GigabitEthernet1/0/48:
CTS is enabled, mode: MANUAL
IFC state: SAP_NEGOTIATING
Authentication Status: NOT APPLICABLE
Peer identity: "unknown"
Peer's advertised capabilities: "sap"
Authorization Status: NOT APPLICABLE
SAP Status: UNKNOWN
Configured pairwise ciphers:
gcm-encrypt
Replay protection: enabled
Replay protection mode: STRICT
Selected cipher:
Propagate SGT: Enabled
Cache Info:
Expiration : N/A
Cache applied to link : NONE
Statistics:
authc success: 0
authc reject: 0
authc failure: 0
authc no response: 0
authc logoff: 0
sap success: 0
sap fail: 5225
authz success: 0
authz fail: 0
port auth fail: 0
L3 IPM: disabled.
CTS sgt-caching Ingress : Disabled
CTS sgt-caching Egress : Disabled
![VPLS_MACSEC.png VPLS_MACSEC.png](https://community.cisco.com/t5/image/serverpage/image-id/14233i37AE8F202DEA42DD/image-size/large?v=v2&px=999)