cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4144
Views
0
Helpful
2
Replies

mpls ip-ttl-propagate disable forwarded in IOS XR

j.restaino
Level 1
Level 1

Hi,

I have a network with MPLS VPN L3, i am using Cisco CRS like P and ASR9000 for PE. I try to hide my links between PE - P and P - P, so i configured in my network mpls ip-ttl-propagate disable forwarded. The problem that i have now, is when i make a traceroute from a CE to another CE, the Egress PE does not respond the icmp unreachable with a source IP in the VRF, instead of this the source IP is the IP that i have assigned to the pe in the link between P and PE.

#traceroute 192.0.2.6

  1 192.0.2.1 4 msec 0 msec 0 msec
  2 10.0.0.10 4 msec 0 msec 4 msec
  3 192.0.2.6 4 msec 0 msec 0 msec

If i try the same configuration in a testing network with IOS instead of IOS XR, the egress PE respond with an IP asiggned to a VRF interface like i hope.

#traceroute 192.0.2.6

  1 192.0.2.1 4 msec 0 msec 0 msec
  2 192.0.2.5 4 msec 0 msec 4 msec
  3 192.0.2.6 4 msec 0 msec 0 msec

I attached the topology that i am using

I will appreciate if someone could help me.

Regards
                        José

1 Accepted Solution

Accepted Solutions

Nagendra Kumar Nainar
Cisco Employee
Cisco Employee

What version are you runing?.

 

Can you try "icmp ipv4 source vrf" and try the trace again?.

 

-Nagendra

View solution in original post

2 Replies 2

Nagendra Kumar Nainar
Cisco Employee
Cisco Employee

What version are you runing?.

 

Can you try "icmp ipv4 source vrf" and try the trace again?.

 

-Nagendra

Thanks Nagendra, this command resolve my problem ... The trace looks fine now.

I am using IOS XR 4.3.4

Regards
                     José

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: