MPLS

HiWe are facing issue of ldp flapping continously in our mpls network. 3: Jan  9 12:47:12 IST: %LDP-5-NBRCHG: LDP Neighbor 10.135.254.21:0 (0) is DOWN (Received error notification from peer: KeepAlive expired)1046264: Jan  9 12:47:13 IST: %LDP-5-GR: ...

I wonder how can we advertise same subnet from two different locations. Those two locations are connected to MPLS cloud and have back to back connection with each other running EIGRP. What are best practices? Using MED? and priotizing one of the loca...

Hi, I have a strange CEF behaviour and I need to know if it's normal or not:This is a subnet of a PE router's loopback interface in the MPLS network. As you see, I have configured the loopback with /24 length intentionally and have received it via IS...

Please take a look at the diagram which depicts a lab I set up in order to get this technology working for a production network. As you can see from the diagram the test set is sending 5,000 Cells/sec and those cells are sent 100% throughout the netw...

       Hi allDSLAM----(PPPoE)---7600----(Xconnect)----7600----(VLAN/PPPoE)---(BRAS ASR1K)we currently have a distributed access network where the DSLAMs send us PPPoE packets which we are wrapping into xconnects back to a central BRAS.the xconnects t...

Hi all,I cannot seem to get Native IPv4 Multicast PIM-Joins to be mapped to an mLDP LSP on IOS-XR 4.3.2.  Is this even supported on IOS-XR 4.2.3?      Thanks,DL   

hi     am just doing simple testing from juniper to cisco router.. creating  MPLS L2VPN between Cisco To Juniper.. In Cisco 7206 -  Serial1/0.1/3/1/3:0   encapsulation pppJuniper end - gigabit interfaceencapsulation pppcan any one suggest me...

Hi experts,Need help .CustomerMGW-----SW-(trunk)--------(2 Sub-interface)-PE1-----------------PE2MGW is telecom device.PE1 and PE2 is directly connected with gig port.MGW is customer.Form MGW device to connection is terminating on SW and they assigne...

Hi,why is it necessary to redistribute bgp to ospf to get sham-links to go up in IOS/XR? With IOS this doesn't seem to be necessary.Regards,Joerg

Dears ,here is my  topology 4507(Edge)--layer2-->(Core)6509-->ASA 5500-->ASR1002        ---MPLS CLOUD ---> In the 6509 and 4507 i am working with PVLANs , i would like to extend the layer2 (PVLANs) to the MPLS cloud using VPLS my questions are :-1-I ...

Hello, I have activated MPLS on several interfaces on Cisco 7604 (IOS: c7600s72033-advipservicesk9-mz.122-33.SRC.bin) and I'd like use NetFlow for monitoring. NetFlow export is working, but I can see only untaged traffic. Is it possible use NetFlow w...