Hi All,
I'm looking to set up an MPLS lab using kit and was wondering if anyone had any experience using 2651XM's for this purpose?!
I threw c2600-advipservicesk9-mz.123-4.T6.bin on one 2651 to check MPLS support and all the commands seem to be there.....
Router-1(config)#mpls ?
atm Configure ATM options
ip Dynamic MPLS forwarding for IP
ipv6 Dynamic MPLS forwarding for IPv6
label Label properties
ldp Label Distribution Protocol
traffic-eng Configure Traffic Engineering parameters
As i'm looking at investing in another five 2651XM's does anyone know if the MPLS support in 12.3 is full or cut down? Can i acomplish a full on MPLS lab using this set up or Is it worth investing in different kit? (no GNS3!)
Thanks in advance!
Adi
