MPLS

I have two questions and I have find it every hard find the answers.1. send-label.When you send-label  through BGP for PE loop-backs addresses, it should be in sh mpls  forwarding. But it is not, but when do sh mpls forwarding x.x.x.x, it is  showing...

Hey Folks,I've seen about a dozen docs on EVN w/ some IGP's etc., but nothing yet illustrating EVN with BGP - know where I can find some?Thank You!

Hi, I would like to know various types or mode of VPLS. As per Cisco standerds its: Port mode and VLAN mode.Now I would like to know if I can use the PE interface connected to CE as a trunk interface and carry all customer VLAN via that port? Instrea...

Hi,My provider is trying to sale me an MPLS VPN with below CoS specification:CoS1: packet delivery=99.95%, jitter=5CoS2: packet delivery=99.9%, jitter=10I wonder:1. How they actually config on PE that to get that number? or they just use LLQ for CoS1...

HI, All:I want to extend MPLS Branch to some off-site where there is no MPLS service. I wonder if it is possible to build IPSEC tunnel from the off-site to the branch? The tunnel endpoint will be off-site and the branch internet GW. By doing this, I ...

Hi Guys,I'm having issues with my xconnect tunnel. i couldn't ping from CE to CE. is theres something that i missed in my config? CE2#sh run int Gi0/0.1104Building configuration...Current configuration : 201 bytes!interface GigabitEthernet0/0.1104enc...

What is the different between "Service Instance" and "xConnect" ?

I'm trying to only mpls what I need to mpls and nothing else.Here's the idea:interface te1/1ip address x.xmtu 9000...etc..interface te1/1.50encap dot1q 50ip address x.x.x.xmpls ipvrf forwarding VRF2..etc..Mpls only running on te1/1.50 and not te1/1Te...

N/A

Hi,I am trying to export host routes from a connected network from one VRF to multiple other VRFs. This is to allow the leaking specific host routes for management purposes. However, I suspect that the /32 host route(s) actually need to be present in...

Hi,I need to re-design a network and i'm looking for informatcion about hierarchical VPLS, how it configure ? Thanks

I am having two Cisco 6509(R01,R02) connecting back to back with MPLS LDP enabled then i try to test VPLS VPN with VLAN AC.R01's LDP Router ID is 111.90.180.8 , R02's LDP Router ID is 111.90.180.9. I got below output:R01#sh mpls l2transport vcLocal i...

Does ASR1K support VPLS? or only P2P L2 VPN only? I saw address-family l2vpn is available in BGP. But i can not config VFI on any interface (subinterface or phy).Regards,CT

I am working with ME3600 as PE which does not support policy routing. I am trying to use static routes to achieve the same. The basic setup is standard and works well. MPLS traffic engineering tunnel are set up between PE, as shown here. I’m not show...