08-24-2006 09:37 AM
Hi ,
I tried to configure MPLS over a TE tunnel by following this link : http://www.cisco.com/en/US/tech/tk436/tk428/technologies_tech_note09186a0080125b01.shtml#case1 .
The problem happened in this tunnel interface config :
----
!
interface Tunnel0
ip unnumbered Loopback0
no ip directed−broadcast
no ip route−cache distributed
tunnel destination 10.5.5.5
tunnel mode mpls traffic−eng
tunnel mpls traffic−eng autoroute announce
tunnel mpls traffic−eng path−option 10 dynamic
end
!
----
The int tunnel 0 is always in "Tunnel0 is up, line protocol is down" state .
My PE routers are 7304s(p-mz.122-27.SBC5)
Please advice !
Thanks & Regards
08-24-2006 10:56 AM
If you do a "sh mpls traffic-engineering tunnels tunnel 0", was is the info that is displayed? Please let me know.
Thanks.
08-24-2006 11:45 AM
Did you configure MPLS specific statements under your IGP (either ISIS or OSPF) as follow:
OSPF:
mpls traffic-eng router-id Loopback0
mpls traffic-eng area 0
ISIS:
mpls traffic-eng router-id Loopback0
mpls traffic-eng
Also did you configure all interfaces for mpls traffic engineering between the headend and the tailend using the following statements:
mpls traffic-eng tunnels
ip rsvp bandwidth
Hope this helps,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide