Ping to PE interface

[dangal.43]

I configured the MPLSVPN in my test topology which is chain of 6 router 1 and 6 routers are CE routers and all other are for provier network in which 2 and 5 is PE1 and PE2 router, as PE-CE communication i am using RIP, In both the CE router i have configured 3 loop back interface as internal network.

Here i can see the loopback of each other CEs in their routing tables but i cannot able to ping those loopbacks why?

other strang thing is i can not ping the PE routers interface which are connected with the CE routers so i want to know why i cannot ping the PE routers interface facing to CE routers?

How can i make all those loopback reachable to each other?

[swaroop.potdar]

Ken, yes you can run MPLS on a 2600.

Here is a previous thread which discusses the same and the support available for it in 2600.

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Service%20Providers&topic=MPLS&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddc801e

This should be helpful.

HTH-Cheers,

Swaroop