cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1153
Views
0
Helpful
4
Replies

QoS over MPLS L2VPN (EoMPLS)

Aaziz AMHAOUCH
Level 1
Level 1

Hi all,

How can I implment QoS (Marking and Bandwidth reservation) over EoMPLS ? The customer is connected to PE (Cisco 7600 Series):   NTU(Customer) --> Aggregation Switch (vlan) ---> PE (SVIs/Subinterface) 

 

Thank you in advance.

 

Best Regards,

Aaziz

4 Replies 4

Hello.

Could you please provide:

 - running configuration of CE-facing interface;
 - show ver;
 - show module;
 - what is your core-facing interface/LC?

Hi Vasilii,

Thank you for your reply. Please find attached the information you requested.

Best regards

 

Hello.

Sorry, I didn't get how G0/0/0/4 (does it exist on 7600?) could be a CORE facing interface?!

Did I understand correctly: is your question about inbound and outbound QoS on PE device (CE facing interface)? If not - could you please clarify?

Hi Vasilii,

Thank you for your reply.

The Core-facing interface configuration is as follow:

interface TenGigabitEthernet7/1
 mtu 4470
 bandwidth 10000000
 ip address 172.16.0.4 255.255.255.252
 no ip redirects
 no ip proxy-arp
 ip router isis ISISCORE
 load-interval 30
 carrier-delay msec 0
 mpls propagate-cos
 mpls ip
 bfd interval 100 min_rx 100 multiplier 3
 isis circuit-type level-2-only
 isis network point-to-point 
 isis metric 5 level-2
 isis authentication mode md5
 isis authentication key-chain KEY-ISISCORE
 isis bfd
 service-policy output 4class

You are right about my question: it's a about inbound and outbound QoS on PE device for EoMPLS.

Best Regards,