Hi Guys,
I have a segment routing metro ring with 4 equips and the convergence time after a failure link is about 10 seconds. In theory convergence time would be about 50ms. Any idea what is occurring ? A brief topology and sampling of the configuration involved is following:
Topology Ring:
ASR9010-1 <> ASR920-1 <> ASR920-2 <> ASR9010-2
ASR920 Sample configuration:
router ospf x
router-id x.x.x.x
segment-routing area 0 mpls
fast-reroute per-prefix enable prefix-priority low
fast-reroute per-prefix ti-lfa
microloop avoidance rib-update-delay 10000
interface TenGigabitEthernet0/0/26
mtu 9216
ip unnumbered Loopback0 poll point-to-point
ip mtu 9202
ip ospf authentication key-chain ospf-key
ip ospf network point-to-point
ip ospf bfd strict-mode
ip ospf cost 10000
load-interval 30
carrier-delay down msec 1
cdp enable
bfd template SRRING
interface TenGigabitEthernet0/0/27
mtu 9216
ip unnumbered Loopback0 poll point-to-point
ip mtu 9202
ip ospf authentication key-chain ospf-key
ip ospf network point-to-point
ip ospf bfd strict-mode
ip ospf cost 10000
load-interval 30
carrier-delay down msec 1
cdp enable
bfd template SRRING
bfd-template single-hop SRRING
interval microseconds min-tx 5000 min-rx 5000 multiplier 3
