Hello,
First time poster and was hoping to get a kick in the right direction with my problem.
I am attempting to route between two VRFs on the same Cisco 7606-S. Ex: VRF-1----Gi1/1----PE-1-----GIi1/2-------VRF-2
Is this suppose to work?
I believe that this is known as "VRF Leaking". I am doing this on a WS-X6724-SFP card. The supervisor is a RSP720-3CXL-10GE.
When I setup route leaking between two VRFs that use a loopback interface, I have no issues and can ping in both directions.
When I do the same test between two physical interfaces on the same router. The routes appear in the VRF table; however, traffic is dropped.
Attatched is a snippet of my config.
To help determine if it was a limitation of the line card. I have done the same test across two WS-X6724-SFP on the same 7600,
Gi1/1 to Gi3/1. Unfortunately the results were the same.
If anyone has any thoughts or opinions on what may be wrong, I would be extremely greatful.
Kind regards,
Tim