cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1876
Views
0
Helpful
1
Replies

ACS 4.2 - is it possible to change replication port?

Hi,

trying to find out if it some tweek to change the ACS replication port TCP/2000 to something else.

I know it's possible to make a different policy-map or to not inspect the Skinny protocol to avoid conflict, but that not the solution I'm looking for. Wondering if anybody knows of a different way to change the replication port in ACS 4.2.

1 Accepted Solution

Accepted Solutions

andamani
Cisco Employee
Cisco Employee

Hi,

what is the version of ACS you are running?

If you are running ACS 4.2.1.15 then,

Problem :
=========
ACS replication port re-configuration.
 
Resolution :
============
Please follow the following steps:
1.       Interface configuration > Advanced Options > Check the checkbox ACS
Communication Port Configuration.
2.       System Configuration > service control > Configure the Port to be
used for the ACS Internal Communication (choose any port between 2010 to
2025)

Regards,
Anisha

P.S.: please mark this thread as resolved if you think your query is answered.

View solution in original post

1 Reply 1

andamani
Cisco Employee
Cisco Employee

Hi,

what is the version of ACS you are running?

If you are running ACS 4.2.1.15 then,

Problem :
=========
ACS replication port re-configuration.
 
Resolution :
============
Please follow the following steps:
1.       Interface configuration > Advanced Options > Check the checkbox ACS
Communication Port Configuration.
2.       System Configuration > service control > Configure the Port to be
used for the ACS Internal Communication (choose any port between 2010 to
2025)

Regards,
Anisha

P.S.: please mark this thread as resolved if you think your query is answered.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: