01-20-2011 11:14 PM - edited 03-10-2019 05:44 PM
Hi,
trying to find out if it some tweek to change the ACS replication port TCP/2000 to something else.
I know it's possible to make a different policy-map or to not inspect the Skinny protocol to avoid conflict, but that not the solution I'm looking for. Wondering if anybody knows of a different way to change the replication port in ACS 4.2.
Solved! Go to Solution.
01-20-2011 11:20 PM
Hi,
what is the version of ACS you are running?
If you are running ACS 4.2.1.15 then,
Problem : ========= ACS replication port re-configuration. Resolution : ============ Please follow the following steps: 1. Interface configuration > Advanced Options > Check the checkbox ACS Communication Port Configuration. 2. System Configuration > service control > Configure the Port to be used for the ACS Internal Communication (choose any port between 2010 to 2025)
Regards,
Anisha
P.S.: please mark this thread as resolved if you think your query is answered.
01-20-2011 11:20 PM
Hi,
what is the version of ACS you are running?
If you are running ACS 4.2.1.15 then,
Problem : ========= ACS replication port re-configuration. Resolution : ============ Please follow the following steps: 1. Interface configuration > Advanced Options > Check the checkbox ACS Communication Port Configuration. 2. System Configuration > service control > Configure the Port to be used for the ACS Internal Communication (choose any port between 2010 to 2025)
Regards,
Anisha
P.S.: please mark this thread as resolved if you think your query is answered.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: