acs se 1113 - manually set ip does not work

[rhub]

hello everybody

i have 2 new acs 1113 (code-level 4.0(1.44).

setting manually ip-address, subnet-mask, dns during initial configuration of the ACS SE via serial cable/ terminal emulation is ending with the error-msg "Cannot set new NIC configuration".

performing a "show ip" displays the factory defaults (e.g. dhcp=yes)

screen-shot:

*******************************

set ip

Use Static IP Address [Yes]:

IP Address [169.254.253.207]: 10.100.201.109

Subnet Mask [255.255.0.0]: 255.255.255.0 Default Gateway []: 10.100.201.1

DNS Servers (Separate multiple servers with a space) []: 10.100.202.100

10.100.202.101

New Configuration:

DHCP: No

IP Address: 10.100.201.109

Subnet Mask:255.255.255.0

Default Gateway: 10.100.201.1

DNS Servers:10.100.202.100 10.100.202.101

IP Address is reconfigured.

Confirm the changes? [Yes]:

Error: Cannot set new NIC configuration

*******************************

any hints are very welcome

thanks very much for support

roman

[cscherb]

Did you use the NIC1 connector (the lower one) http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_guide_chapter09186a008068f7f2.html#wp1049397

[rhub]

hello

thanks very much for your reply. yes, i used this nic but i solved the problem by myself. i had to reimaging the acs-box from the recovery cd and everything was o.k. knows the hell why :-)))