Network Access Control

Hello,I’m trying to setup following environment:WLC 5508 (OS 7.5)Up to 60 Access Points 1602ITwo SSID’s are requiredWPA/WPA2 Authentication is requiredMAC-Filter should also be usedI’ve done the following configuration:LAN Enviroment worksWLC Setup w...

Hello,How can I do user account never disable on Acs 5.x? Regards,

Hello Community, i want to know, if its possible to check with Cisco ISE if a ccmputer account in active directory is set enabled/disabled.We got an authorization aolicy working and want to add a check, that just enabled computer accounts in the acti...

I am trying to test an access policy in ACS 5.3, but I am unable to find how to use the new policy with a specific switch.  This is a live system and I cannot modify the "default device admin" policy until the new one is tested.I suspect it is a conf...

I'm migrating a Cisco ACS 5.4 Cisco ISE 1.2.1, I am creating a Profile Authorization to allow access L2TP VPN using 128-bit MPPE.I have 2 attributes called MS-MPPE-Encryption-Policy and MS-MPPE-Encryption-Types in the ACS and I can choose values smoo...

Hi to all,is there any way to selective restore items from an acs backup file?I need to restore an primary ACS 5.3 configuration to a new  ACS running 5.6 in order to do some tests before upgrading to 5.4 and then 5.6 but I need to be sure that distr...

Hello! I am currently using the open source TACACS+ server called "tac_plus" for Linux distributions. I have configured the configuration file correctly, I am able to log into ASDM using the one of the account's credentials created without an issue w...

Hi all, I am planning to add an additional node to an existing standalone ISE. I am however unsureabout the creation of the certificates. At the moment I am using a Thawte SAN windcard certificateon the primary host. The current host is located in a ...

HiI would like to find out if one can change the domain of the ISE to another domain after ISE has fully been implemented or do i have to rebuild the server again. ise version is 1.1.1i would like to change from xyz.abc.com to just abc.comthanks

Hi, Has anyone faced the below issue while doing backup.? I found that it was documented in a bug and shown as fixed but still getting even with patch 2https://tools.cisco.com/bugsearch/bug/CSCuq63732/?referring_site=bugquickviewclick Sun May 24 10:4...

Hi All,Can we able to create an admin username and password with role admin in the cli.I have access to the cli using a user account and I was trying to create an admin username and password.I have created one but i cannot access using those credenti...

I have below config on switch (C2960S-UNIVERSALK9-M), Version 15.0(2)SE7,aaa group server tacacs+ testgroup server name test1 server name test2 server name test3tacacs server test1 address ipv4 192.1.1.1 key 7 testkey timeout 3 single-connectionSimil...

Hello,say I want to have five ISE 1.3 nodes behind load balancer, I want only only G0 behind LB, and G1 interfaces will be dedicated for certain things. Specifically I want to use G1 interface for Redirected Web Portal access (could be CWA, device re...

Hi everybody;I read Cisco Trustsec document and want to ask some questions: 1. as I understand, in Cisco TrustSec domain we need to have at least one authenticator device at anytime. if we have just 1 switch in the network, it will act as authenticat...