Network Access Control

Dears,Is there any way to configure ASA as an EZVPN Server, authenticate and authorize the clients using tacacs on the ACS by downloading ACLs per user?Please advise.

Does CSACS 4.2.0-124 or ACS 4.2.1 support remote agent on 2008 R2 64bit OS?

Hello,I have a ACS 4.2 Appliance integrate with Active Directory, CA and Remote Agent, i want to agregate another ACS 4.2 Appliance with the same configuration, the same Active Directory, CA. my question is: can i configure the another ACS with the s...

Hello,I have an ACS 4.2 Appliance integrated with AD and CA in Windows 2K3 both of then working OK and Remote Agent, but we want to change the IP Address of the ACS 4.2 Appliance, What is the procedure to do this? have i install the certified again? ...

Hi, Has anyone try to install ACS Remote Agent in Windows server 64Bit Version. And, Are there any document stating it can be install in 64Bit OS.Thank you

Hello all,I have some problems with the dynamic users. I want to move them to another group and do some changes on userid, but I also want that they are replicated then. The first is no issue, the second is, since they stay flagged as "dynamic users"...

I want to setup a couple of users in TACACS using ACS 5.1 to only be able to login to the ASDM and monitor the device.The documentation is a bit confusing from the ASA ASDM as it says:1.TACACS+ users—Authorization is requested with the "service=shell...

Hi, with IOS router and switch I'm able to authorize the user to jump automatically to the correct privilege level in login phase, as configured in authorization privilege field in ACS. With PIX/ASA the jump does not run: why ?thank you in advanceRS

i have configured the network device group and assigned some dummy entries of acs servers have been added. now what i exactly want is, i want to remove the unnecessary entries in NDG ans also which are added in "Not assigned group". because i am addi...

I am trying to get a WLC4404-100 to use a ACS Express 5.0 for authentication to the WLC for administration. I have the device in the ACs but it does not authenticate any users. If i switch to RADIUS on the WLC with Local as secondary in the priority ...

Hi,My ACS is integrated with AD(member of domain server) and ASA(8.2) is authenticating domain users via ACS successfully (by test aaa command) but my SSL vpn users are not able to authenticate with AD however ssl vpn user can authenticate with ACS u...

I'm new to IOS but I'm taking ICND 1 and ICND 2 to catch up. I've gone as far as configuring a 3560 switch from "scratch" in a test environment, and am in part one of ICND 2.Setting this switch up for HTTP administration, I've been prompted repeatedl...

Hi all,        I have Cisco ACS3.2 (windows) and had pix 6.3(4) and access vpn users were authenticating from ACS with radius protocol.I upgraded pix ios to 7.2(2), now access vpn users can authenticate till group and cannot authenticate user credent...