Network Access Control

Hi AllWhen trying to deploy new passwords to switches via Cisco Workswe get the following error message -ERROR:RME_CDL1031:Transport session to device failed TFTP: failedCould not detect protocols running on the deviceWe can talk to said device with ...

1. Suppose we have mutliple Radius server in a Netowrk. If primary Radius server goes down , how secondary server will come into the picture..2. Where can we check ,which Radius server is active (Primary or secondary Radius server)3. Is there any lim...

Dear,I am planning to implement AAA TACAS level authentication option on my Solaris (OS) Servers. (All my servers are Sun Servers)Is Solaris supports AAA TACAS?If its not supportive any patchs or any upgrade can support the TACAS optionAny other alte...

Hi, I have a ACS Server version 4.2 and at the same time i have a Wirless Controller Device on my network.I have given only limited user access to  the Wireless Controller through ACS.The Users are configured in the ACS through which they are logging...

Hello guys,I'm seeing some unknown users in my router when I use the command SHOW USERS.    Line       User       Host(s)              Idle       Location 706 vty 0     celi    idle                 00:00:04 205.209.X.XI think they are trying to acces...

Hello to everyoneWe have a problem with Cisco 2950G 48 EI and ACS (version 4.2) providing dynamic Vlan assignment based on groups On the ACS we configured the following attributes for the specific group64 = VLAN 65 = 802 81 = VLAN NameWe tried for th...

Hello allWe have Cisco ACS 4.1 and we need to know how to configure the user passwords to expire at determinate time and ask the user to change it.its that possible?thanksregards...

hi..i have asa 5400,can i make NTP server on asa 5540.

I am running a Windows box with ACS 4.1 on it and I have all my routers and switches authentication to it.  Recently I was assigned a task to set up a service that would log commands that are input into my devices.  Is it possible for the ACS to reco...

Hi,I have x2 ACS v4.2 servers in a test environement, I wish to use one as primary and the other as the secondary.  So in essence I want to duplicate the users, groups, and other settings from the primary onto the secondary.  Does anyone have documen...

Mates,i would like to add Administrators to the ACS 5.1 System. The Administrators should be users from our active directory. I could set up only local users and assign them Admin rights. Is there a way to assign admin rights to domain users?regardsA...

I have been mulling over this issue on and off for some time now.  I have an ACS server which i am using to authenticate both the AE units and the central manager.  TACACS+ works perfectly with regards to authenticating via the CLI, but i am having t...