Network Access Control

We have 2 ACS SE with 4.1.1.23.5 , but one them is sending a message in Reports and Actvity -> ACS service monitoring -> CSLong.csv, that goes like this:09/11/2008 11:25:47 .. Could not generate valid Password. Could not generate valid Password. 354 ...

Hi, I want my 2851 to stop allowing login attempts after 3 failed attempts and to (if possible) send an email to the network administrator about the failed login attempts. Can anyone help with this?Thanks in advance! Mitchell

I want to upgrade an ACS appliance 1113 with the version 4.0.1.44 at 4.1.4.13. the steps for the upgrade know them. But I have doubts about if I will lose data in the database, since it is very important.Thank youregards

Hi, how are you??I have problems with same ACS 4.2 with Peap authentication. Not all but same machines does not authenticate. When you go to the Fail attemps in the ACS logs you can see this mesege "Authen session time out : Challenge not provided by...

Hi,we are having almost 150 NDG groups in my ACS Server, in that one group is specifically for Security devices like pix & ASA's.Now My requirement is that i want to Restrict this Security NDG group to one Specific Group under Group setup menu in ACS...

Hello.We have a Secure ACS 4.1 Solution Engine. I would like to use the Remote Agent CLI to export users but I don't understand how (or where) to launch the Remote Agent CLI. Does it run from one of our Remote Agent workstations? Any help would be gr...

HelloGot a windows AD with a Cisco ACS 4.2 setup infront of it.I have configured so that our firewalls (pix/asa) has AAA configuration now and it works well.But today when I was gonna configure our switches with the same login system i've encounterd ...

Basically I want to have two gateways configured in my ACS SE v4.2. Would it be possible?I'm doing this because I don't have routing capability to AAA all network devices in different subnets.Thank you

Hi,Is there a recommended patch level for ACS 4.2? I see a patch 4 and 5 can be downloaded. Any gotchas with either?thanksBob

I have configured client to gateway VPN's to authenticate with AD using Kerberos. What I am trying to do is get LDAP authorization to only allow members of a certain OU to log in. Is this possible by setting the DN to look at one folder and only allo...

I have a problem with ACS, I only want to give users access to gig1/0/1 but ACS matches 1/0/10, 1/0/11, 1/0/12...1/0/19 in my command set (the statement is set to permit GigabitEthernet 1/0/1). How do I tell it to match only 1/0/1 and nothing else?Th...

My customer wants to upgrade its ACS 2.6 to 4.2 without loosing its database. From the documetation I've found upgrade path: ACS 2.6 ---> ACS 3.x --> ACS 3.3.x -----> ACS 4.1.1.23 or ACS 4.1.1.24 ----> ACS 4.2However how could I get the old upgrade p...