Network Access Control

RRAS (not IAS!) on W2K opens ports 1645,46. When I try to install ACS 3.2 it says that radius ports are alredy opened. What should I do if I need RRAS and ACS on the same server?

Hi,I'm trying to get "autocommand"s to work using Radius validation.To be specific:A certain user ("ciscobackup") should have o) its password validated via Radius and then o) a locally (i.e. within the IOS-config) configured autocommand should be run...

I have a VPN concentrator that is configured for client authentication using an NT domain. I dont want every account in Active Directory to have VPN access, so i was wondering if it was possible to limit the scope of where the vpn 3000 looks for acco...

Is anybody successfully utilizing Linux for the TACACS+ or RADIUS authentication?Thanks

Hello group,We currently have a PIX 501 to PIX 501 vpn between two offices. Wehave an AS400 at the main site. At both locations we would like theusers to authenticate to the PIX locally for internet access. Iunderstand that the PIX allows for telnet,...

Hi, I am using ACS for Authentication for Access-server. I am using RADIUS for authentication. Now If the user is connected and it has a 1 hours time remaining in his account. Now if this user is authenticate and use the services, and between this if...

Hi,I’m using Cisco acs 3.1 Build 27 but some users that defined in ACS have been duplicated! Anybody know how can resolve this issue?I would be appreciate if you advice me.Regards,Mehrdad Rad

Where storage the user and password the ACS 3.0 for windows? and,This information (user and passord) is protected?and,How are protected? are encripted? What type of encriptyon is used?Thanks

Hello..I am using the ACS v2.6 in Windows2000.I want to limit the user session in ACS..All user can login to Router in one session at a time.I tried to set it in user setup, but it didn't work.I really want to know how to setting it...

There are two RADIUS servers - Cisco ACS and some freeradius. Both servers are proxy servers for each other - we have on our distribution table their RADIUS as proxy, and they have ours. Problem - we can authenticate to their RADIUS with their userna...

Hi gurus,Please help:acs (net172.16.1.12)---PIX(10.0.20.1/28)-----(10.0.20.32/28)PIX----NASRouter (Fa0/0 192.168.0.1)--Dial-in User. NOTE: --Between PIX there has 2 network coz go throughservice provider --The Fa0/0 has being NAT-ed to 10.0.20.46. --...

I'm trying to use ACS 2.6 and ACS 3.2 as a radius server to for my Msft win-xp client to do authentication before it brings up its pptp client.To that end, on ACS, I enable the attributes:MS-CHAP-MPPE-Keys (N/A)MS-CHAP-MPPE-Types (128 bit)MS-MPPE-Rec...

Hello,I have a LNS configured to send start and stop accounting messages to the Radius server.It seems some stop messages aren't received by the server.Is there a retransmission timer for the accounting stop messages ?Thanks

Which is the behaviour of a LNS in such a situation :A Radius server sends an access-accept with an IP address which is already linked to a PPP session.Does the LNS maintain the PPP session and refuse the creation of a new one, or does it react by de...