Network Access Control

HiI have configured my Aironet AP350 for two type of client. Client that are EAP authenticated and client that are MAC authenticated. I want that EAP client have access to all my network resources and that the MAC client have access to only few resou...

I have pouches a Cisco ACS v2.6 for WinNT/2000 for my Corp, and I need to install (well I install) this Cisco ACS v2.6 for WinNT/2000 in one of my branches in other country with the same NT domain and I like to Know if cisco permit this, in ot...

Any one know if you the 3000's work with a ACS 2.4 server?

I would like to restrict access to particular NASes for a given group in Cisco ACS.Unfortunately, the fields "NAS (Telnet/Login/Exec) Access Control" are in grey and I cannot use them.Did anybody already experienced this kind of problem?Thanks for yo...

Will Cisco ACS v2.6 for WinNT/2000 reject a connection request from a NAS while the database is down for replication, or will it accept the request and just not be able to service the authentication? I'm trying to verify that the NAS (an iPass RoamS...

Our environment :1 Internet access1 local PIX 515 with AAA to 1 Cisco ACS with RSA/ACEx local Web serversOur need is to authenticate remote Internet user (with securID card) requesting access to our internal Web servers.After authentication succeeds,...

We are Running a Cisco VPN solution for dial-up users. Using the Cisco client V1.1 they are authenticated using the Cisco ACS server. However when they authenticate they always get the message NO domain Server was available to Validate you Password.H...

I'm trying to look for the right ACS version to use LEAP over CIsco Wireless 352.I think that the version should be ACS 2.6.2 but I can't find anything on CCO.

I have come across a situation where we need a clarification of AAA behavior. I found the following excerpt at URL - http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/secur_c/scprt1/scaaa.htmNote A FAIL response is significantly...

We are using PIX 515-UR. We have set up static routes to the high security network and are able to connect to specific servers on the inside. We are now looking at setting the AAA options. Never tried one setup, could anybody indicate the minimum req...

Need basic RADIUS and aaa command line for 2511 access router. Using sample configure for basic radius and aaa. Using MS IAS. For some reason it will no authentication between router and radius server.

Greetings,We are using Websense Enterprise 4.3 on an NT 4.0/SP6 server, in conjunction with a PIX 515 using software release 6.0(1). I am unable to get "manual authentication" to work. Though the user is prompted for login/password, and enters valid...

Hi,I am using L2F protocol for vpdn and am able to get authentication for local user like sumeer@cisco.com but it disconnects after 60-90 seconds.Any comments ?

I effected an aaa new-model on my remote cisco router.I cant login its asking for username which i didnt put.Is there a default username that i should use to access this router .please help.

I noticed that CSIDS ver 2.2.1 cannot manage router with TACACS+ Authentication (i.e. username/password & enable). It only can managed router with just password & enable.Is this correct ?