08-29-2024 10:42 PM
Hi what is the best way to change ISE network interface. by default, it is using the copper port but we need to use the 10gb SFP port. can we shutdown the eth0 and config the ip on the spf port? or set the sfp port as secondary port the just connect the network there?
08-30-2024 04:25 AM
which hardware appliance are you using ?
09-01-2024 06:02 PM
SNS-3715
08-30-2024 04:35 AM
Add IP to interface then use
Ip route 0.0.0.0 0.0.0.0 gateway <IP of new interface>
Then check config via
Show ip route
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide