Cisco CIMC IP address filtering

[adamscottmaster2013]

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/sw/gui/config/guide/4_1/b_Cisco_UCS_C-series_GUI_Configuration_Guide_41/b_Cisco_UCS_C-series_GUI_Configuration_Guide_41_chapter_01010.html

n the IP Filtering (Whitelisting) area, update the following properties:

 Name Description

Enable IP Filtering check box	Check this box to enable IP filtering.
IP Filter fields	To provide secure access to the server, you can now set a filter to allow only a selected set of IPs to access it. This option provides four slots for storing IP addresses (IP Filter 1, 2, 3, and 4). You can either assign a single IP address or a range of IP addresses while setting the IP filters. Once you set the IP filter, you would be unable to access the server using any other IP address.

However, it does not tell you the format.  Anyone has done it before can tell what the format looks like without guessing what they are?  TIA

[Marcelo Morais]

Hi @adamscottmaster2013 ,

 it's better explain in the CLI Configuration Guide than in the GUI Configuration Guide.

 Take a look at Configuring Network Security (link above):

"... you can set up four IP Filters. You can assign an IPv4 or IPv6 IP Address  or a range of IP Address ..."

"Example: ... filter-1 1.1.1.1-255.255.255.255 ..."

Hope this helps !!!

[peter.matuska1]

format is IPstart-IPend, e.g. 10.10.10.0-10.10.10.10