Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,I configured the FMC <-> AD integration for policy creation purposes. The FMC now sees the users from AD. The problem is that according to my research it grab the samAccountName from the user object. Is it possible to change it? I need the user...
Hi,
I configured anyconnect on ftd. Authentication is done agains ISE via RADIUS. Everything works. Now, I would like to see the username in the Unified Events. In Active session I can see Discovers Identities\"username of the connected user" with IP...
Hi,
we’re experiencing an issue where freshly installed Windows 11 PCs are being disconnected from the network exactly 7 days after installation. The devices are connected to a Catalyst 3650 switch (we’ve also seen this behavior on a 9200 series) run...
Hi,
I have 4 VLANs - 10, 20, 30 and 40. VLANs 10 and 20 are VXLAN enabled with L3VNI. Communications works fine between them. VLANs 30 and 40 are for guest access and needs to be VXLAN enabled as well but need to be in different VRF since they cant h...
very nice. ok and how to solve this scenario: Users have certificates where UPN is used in template. When I use only cert authentication the UPN doesnt match the downloaded samaccountname so ACP based on AD group is not matched and the user is denied...
i installed 3.4, patch 6 and noticed java error during the login process. after som tshoot I found out that I used wrong guest type at the creation of the account. Once I fixed that the java error was gone and the temporal posture agent worked.
my ipsec was between MX and ASAv. The problem was that phase2 was not able to establish under any condition while on 19.2.7. after upgrading to 26.1.2 everything started to work
reply from support: It appears that following your upgrade to version 19.2.7, your device began experiencing a known issue that has already been addressed in firmware version MX 26.1.2 (new public beta). I did the upgrade and everything works now.
