Cisco ISE 2.4 BYOD integration with Meraki

[nathant]

I am interested in configuring Cisco ISE 2.4 BYOD and integrating it with my Meraki MX84, MS320 and MS225 switches and my MR42 Access Point (AP).

I would ideally like to set up a Dual SSID scenario with an isolated "Guest" network (going through the ISE 2.4 on-boarding process) and then automatically connect to the "Authorised" network when permitted by the ISE policies.

I am hoping to use the DHCP and wireless features on the Meraki appliances and enable a Guest redirect to ISE 2.4 .

I have read there is some limitations with integrating ISE to Meraki, and I was hoping to get some more information on if my scenario would be technically possible?

[Jason Kunst · Accepted solution]

Did you follow the meraki ise how to guide on our design integration guide site?


https://community.cisco.com/t5/security-documents/ise-design-amp-integration-guides/ta-p/3621164