CISCO ISE SYNCHS WITH NTP SERVER BUT SHOWS WRONG TIME

[davejumby]

Hi

My ISE has NTP server configured , from the below output it synchronizes with the server but does not get the correct time when I output show clock

 show ntp
Configured NTP Servers:
  172.16.5.1

synchronised to NTP server (172.16.5.1) at stratum 9
   time correct to within 452 ms
   polling server every 64 s

     remote           refid      st t when poll reach   delay   offset  jitter
==============================================================================
 127.127.1.0     .LOCL.          10 l  700   64    0    0.000    0.000   0.000
*172.16.5.1      LOCAL(1)         8 u   19   64  377    0.340    5.481   3.332

* Current time source, + Candidate , x False ticker

Warning: Output results may conflict during periods of changing synchronization.

[Mark Elsen]

 - Is the timezone on ISE configured correctly ?

M.

[Nidhi]

Also, if timezone is correct, try reloading. 

[Jason Kunst · Accepted solution]

Here is an article I found


https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/119371-technote-ise-00.html

[Mannyteck]

Can you send screenshot on how you configured your NTP server.