06-09-2008 09:20 PM - edited 03-10-2019 03:53 PM
Hi from Barcelona
I'm trying to setup Cisco ACS to use PEAP but before that I need to configure a CA on the server. I'm following the procedure found in http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a0080545a29.shtml but I have problems.
When I want to create a Server Certificate, I open the browser from ACS server and type http://localIP/crtsrv/; and when I submit the option 'Submit a certificate request to this CA using a form' , the browser keep thinking with message 'Downloading ActiveX Control'.
This is a W2K Server SP4 and It shouldn't happen. I've tried to install also Microsoft Patch found in Q330389, but it's only for SP3.
Any help
Dani
06-09-2008 09:58 PM
Try to add the ACS server page to the list of trusted sites. Also make sure download of Active X is set to either Prompt or Allowed/Enabled.
Regards
Farrukh
06-10-2008 04:39 AM
Dani,
Try lowering the security level of your browser. This should answer your query,
http://support.microsoft.com/kb/330389
Regards,
~JG
Do rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide