- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-12-2025 09:58 PM
With ISE 3.2, I want to control command of juniper equipment using TACACS.
Juniper uploaded vMX virtually.
When I conducted the test, it was not controlled normally.
When testing with existing Cisco equipment, each time you enter a command, you are authenticated, but Juniper is authenticated once you log in and does not authenticate the command.
I wonder if this is the result of the difference between vendors.
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-19-2025 01:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2025 01:57 AM
@CCC3 I think its mainly dependent on host TACACS is implemented in NAD(Juniper in this case). If NAD support command authorization, I believe ISE can control it. I have no/very little experience with juniper. Did you confirm if it is supported and you have enabled it ?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-19-2025 01:48 PM
