cisco wlc 9800In version 17.3.6I have set up HA
There is no response even if I remove Active's uplink.
However, if the corresponding port is shotdown from the cli, Active will pass normally.
is this a bug?
Cisco 9800 with third-party authentication serversI am trying to integrate through web policy.
I read the manual, but there are many things I don't understand.
1. Is aaa server really necessary?
2. In Authentication of AAA Method ListWhich type is co...
I am using pda through cisco wireless.
and, apWhile replacing it with 9120, the authentication method was changed to 802.1x.
According to the customer, the service has been unstable since the change, and looking at the log of the pda,intermittentlyCo...
If you change the ssid, you will not be able to access the gui for a certain period of time.
Of course, ping doesn't go out either.
And after a certain amount of time, you can connect again.
Is there a command related to that?
*Model : 9800-CL (vWLC)
Thank you for answer.
Both wlc and ap mgmt are using the same vlan 90,You want to use vlan 11, which differs only in user radio bands.
And before changing to 9800Since I was using internal dhcp with 5508, recommending a dhcp server seems unlikely.
so, Management vlan is 90 (10.10.90.x)
user's wireless band.This is vlan 11, 10.10.11.0.
Then, which vlan should be set to the policy?
And do I have to open all ports 67 and 68 in the firewall?