04-05-2020 11:29 PM
Hi,
My cisco ise license is expiring and try to renew but the license won't get on time due to the situation . Is it possible to add a trial license
Thanks
Solved! Go to Solution.
04-19-2020 07:19 AM
Your end users will not be impacted when the license expires.
As noted in my reply from 6 April:
Alerts will be provided every day that a license is out of compliance. For term licenses, alerts are provided, 90, 60 and 30 days before expiry and also for the last 30 consecutive days before expiry.
Impact: There will be no impact to end users. Existing configuration continues to operate without disruption. However, visibility and management of the features associated with an out-of-compliance license will be affected.
04-05-2020 11:41 PM
Your expired license will continue to work for end users. Management of the features for expired licenses will be curtailed.
See the following, quoted from the ordering guide:
Relevant ISE releases: 2.2 and later
Out of compliance: A license is out of compliance when
(a) the deployment uses more than 125% (to account for a temporary burst of usage) sessions compared to the quantity purchased; or
(b) the licenses have expired without renewal.
Compliance enforcement: The impact described below is experienced after a deployment is out of compliance for 45 out of 60 consecutive days.
Alerts will be provided every day that a license is out of compliance. For term licenses, alerts are provided, 90, 60 and 30 days before expiry and also for the last 30 consecutive days before expiry.
Impact: There will be no impact to end users. Existing configuration continues to operate without disruption. However, visibility and management of the features associated with an out-of-compliance license will be affected.
04-07-2020 12:37 AM - edited 04-07-2020 12:37 AM
under license usage ,current usage use shows like below
base : licensed 500 consumed 15000
apex :icensed 500 consumed 0
plus licensed 500 consumed 0
In that case ,how do I calculate the qty required for the base license ?
and Why apex and plus shows consumed 0
second thing , I have now base ,apex and plus , each qty 500 .When I renew do I need to renew the same amount for each
Or I can remove the apex and plus
Thanks
04-07-2020 03:00 AM
It sounds like your deployment is improperly licensed in comparison to what you are using.
If none of your policies use features in the Plus or Apex tiers then you can safely remove the expired/expiring licenses and be just fine.
Base licenses never expire but if you are using 15000 vs. 500 purchased then you are very much out of compliance.
04-08-2020 01:26 AM - edited 04-08-2020 04:05 AM
As far as I know Anyconnect requires apex license , but I am confused why apex does not show any
usage
I am planning to assign ip address based on the users group for wireless users . so I need plus license
One more question , when I renew license still do I need to get support license additionally
Thanks
04-08-2020 09:43 PM - edited 04-08-2020 09:45 PM
First, AnyConnect licensing is never reflected in your ISE deployment. You only need AnyConnect Apex licenses if you are using ISE for Posture/Compliance use case and not using agentless posture. If you have no posture policies then you don't need AnyConnect Apex.
If you are using AnyConnect Network Access Manager (NAM) module as your 802.1x supplicant (which can be done with ISE Base licenses) it only requires AnyConnect Plus licenses (still, AnyConnect licenses - no matter what type - are managed completely separate from your ISE deployment).
04-16-2020 12:11 AM
You are really helpful .
Thanks for the reply . it would be great help if you tell me the difference between the below
1 ) L-ISE-BSE-PLIC and L-ISE-BSE-P3
2 ) L-ISE-PLS-LIC and L-ISE-PLS-1Y-S3
you said "First, AnyConnect licensing is never reflected in your ISE deployment " .
what you mean by
Anyconnect license is on ASA , right ?
Do we need anyconnect apex on license on ASA and ise apex license at the same time for posture/ compliance
Thanks
04-16-2020 11:06 PM
L-ISE-BSE-PLIC is the top level SKU for ISE Base licenses. Depending on how many are in a given order the price varies and a different sub-SKU applies. L-ISE-BSE-P3 is for orders with 500-999 licenses.
L-ISE-PLS-LIC and the associated sub-SKU is similar with the added distinction that Plus (and Apex) licenses are term-based so they also specify the term (1, 3 or 5 years).
AnyConnect Apex licensing on the ASA is necessary if you are doing posture compliance checking for your remote access VPN clients. On the ASA it appears as "AnyConnect Premium" (the old nomenclature) and, no matter how many are in the purchase, activating an AnyConnect PAK on the ASA will always show the maximum number supported by the hardware - not the purchased number. This is because you are licensed per unique users, not by number of potential sessions.
You could also be doing posture compliance checking on wired or wireless clients (non-VPN) and they would also require AnyConnect Apex licenses. In this latter case, no appliance actually monitors usage of those licenses - it is up to the admin to know what is being installed and remain compliant with the terms of the licensing agreement (i.e., with respect to number used).
04-18-2020 10:47 PM
Thanks a lot of your support . My maintenance support team advised to delete the existing subscription license(not trial) for base ,apex plus- 500 qty reach
and add a trial license or base ,apex plus- 100 qty till we get the subscription license . His point is that if base license expired nothing will work , your vpn authentication may stop , wireless authentication fails . Based on your previous reply I tried to convince him authentication process will continue .
what is the impact of deleting the existing license (base ,plus ,apex) ,add evaluation license and later import 500 subscription license .
Any benefit or negative impact .
My current license renewal is under process , I will receive only after subscription license expires .
Thanks a million
04-19-2020 12:47 AM
@bluesea2010 ISE Base licenses generally don't expire (exception being the old mobility licenses but we seldom see those anymore since they haven't been sold for the past four years and had a maximum five year term). So there's no reason to delete your permanent Base licenses.
I don't mean to disparage anyone, but it sounds like your maintenance support team might not be very familiar with ISE licensing. Still, if you want to follow their advise vs. that of someone who's been working with ISE for about 8 years, that's your call.
04-19-2020 01:33 AM - edited 04-19-2020 02:25 AM
The license is bought 5 years back for five year term . So it may be mobility license ?
attached the screenshot , is it mobility license .
" but it sounds like your maintenance support team might not be very familiar with ISE licensing."
That's true . Thats the reason I am following your advise .
Now I got confused . How to verify that I am using mobility license .
Thanks
04-19-2020 03:11 AM
Yes - you have the old Mobility license. It is no longer sold or eligible for renewal.
So you would indeed have to delete the existing license to install a 90-day Evaluation license. However make sure you can get one first - that is, actually get it and confirm it.
Cisco would technically have the right to not issue an evaluation license to a deployment that already has a purchased term license.
Best approach is to buy the proper license that you require. Those are typically issued within 24-48 hours after the sales order is placed in the Cisco system.
04-19-2020 03:18 AM - edited 04-19-2020 03:43 AM
So in that case , if I don't renew I will loose all the connectivity . I have only two days .
currently my apex and plus usage is 0 , so If I renew only base license remote users (VPN) can authenticate ?
Thanks
04-19-2020 07:19 AM
Your end users will not be impacted when the license expires.
As noted in my reply from 6 April:
Alerts will be provided every day that a license is out of compliance. For term licenses, alerts are provided, 90, 60 and 30 days before expiry and also for the last 30 consecutive days before expiry.
Impact: There will be no impact to end users. Existing configuration continues to operate without disruption. However, visibility and management of the features associated with an out-of-compliance license will be affected.
04-19-2020 09:09 AM
"Your end users will not be impacted when the license expires."
I got your point .
I thought this is only for the new license and not for the old mobility license scheme
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide