Hi, Thanks for the reply .   here is my toplogy       In the traceroute output it does not show  asa , instead it show  the R2'S interface ,this is normal ? or to show asa inside interface in the traceroute what should I do ? . Thanks     ... View more

Hi, I have inspect icmp in the  policy map policy-map global_policy class inspection_default inspect dns preset_dns_map inspect ftp inspect h323 h225 inspect h323 ras inspect rsh inspect rtsp inspect esmtp inspect sqlnet inspect skinny inspect sunrpc inspect xdmcp inspect netbios inspect tftp inspect ip-options inspect icmp   inspect icmp will not solve the problem ? And traceroute  requires any additional ports other than icmp ? I mean is there any udp ports need to be opened ?   Thanks     ... View more

Hi, Any options to solve the hiss ? Thanks ... View more

Hi, Thanks for the reply ,  The file is quite long due to the fax dial peer configuration , and I sanitized the user infos , It would be great if you could say which important information are  missing in the config file    Thanks  ... View more

Hi, ISR4321/K9   version 15.5 PRI  Thanks  ... View more

Hi, Here is the   conf    ! version 15.5 service timestamps debug datetime service timestamps log datetime msec localtime service password-encryption no platform punt-keepalive disable-kernel-core ! hostname GW1 ! boot-start-marker boot-end-marker ! ! vrf definition Mgmt-intf ! address-family ipv4 exit-address-family ! address-family ipv6 exit-address-family ! card type e1 0 1 no logging queue-limit no logging buffered no logging console no logging monitor ! aaa new-model ! ! aaa authentication attempts login 10 aaa authentication login default none aaa authentication login ssh group tacacs+ local-case aaa authentication login console none aaa accounting session-duration ntp-adjusted aaa accounting connection h323 start-stop group radius ! ! ! ! ! ! aaa session-id common ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! subscriber templating multilink bundle-name authenticated ! ! ! ! isdn switch-type primary-net5 ! ! c ! ! voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none h323 h245 tunnel disable sip ! voice class codec 1 codec preference 1 g711ulaw codec preference 2 g729r8 ! ! ! ! ! ! ! ! ! ! voice-card 0/1 no watchdog ! voice-card 0/2 no watchdog ! license udi pid ISR4321/K9 sn FDO216778787 ! spanning-tree extend system-id ! redundancy mode none ! controller E1 0/1/0 pri-group timeslots 1-31 ! ! vlan internal allocation policy ascending ! gw-accounting syslog ! ! ! ! ! interface GigabitEthernet0/0/0 ip address 192.168.2.10 255.255.252.0 negotiation auto h323-gateway voip bind srcaddr 192.168.2.10 ! interface GigabitEthernet0/0/1 no ip address shutdown negotiation auto ! interface Service-Engine0/1/0 ! interface Serial0/1/0:15 no ip address encapsulation hdlc isdn switch-type primary-net5 isdn incoming-voice voice no cdp enable ! interface Service-Engine0/2/0 ! interface GigabitEthernet0 vrf forwarding Mgmt-intf no ip address shutdown negotiation auto ! interface Vlan1 no ip address shutdown ! ip forward-protocol nd ip http authentication local ip http secure-server ip tftp source-interface GigabitEthernet0 ip route 0.0.0.0 0.0.0.0 192.168.2.1 ip ssh authentication-retries 5 ip ssh version 2 ! ! ! ! control-plane ! ! voice-port 0/1/0:15 bearer-cap Speech ! voice-port 0/2/0 timing hookflash-out 50 connection plar opx 5111 ! voice-port 0/2/1 timing hookflash-out 50 connection plar opx 5200 ! voice-port 0/2/2 timing hookflash-out 50 connection plar opx 5400 ! voice-port 0/2/3 bearer-cap Speech ! ! ! ! ! no mgcp package-capability res-package no mgcp package-capability fxr-package mgcp behavior rsip-range tgcp-only mgcp behavior comedia-role none mgcp behavior comedia-check-media-src disable mgcp behavior comedia-sdp-force disable ! mgcp profile default ! ! ! ! dial-peer voice 8001 pots destination-pattern 001T port 0/2/1 prefix 00 ! dial-peer voice 8002 pots destination-pattern 002T port 0/2/2 prefix 00 ! dial-peer voice 8003 pots destination-pattern 003T port 0/2/3 prefix 00 ! dial-peer voice 10 pots destination-pattern [135]....... direct-inward-dial port 0/1/0:15 ! dial-peer voice 11 pots destination-pattern 18..... direct-inward-dial port 0/1/0:15 prefix 18 ! dial-peer voice 12 pots destination-pattern 1[0-7,9]. port 0/1/0:15 prefix 1 ! dial-peer voice 202 voip preference 10 destination-pattern 17404... session target ipv4:192.168.1.100 voice-class codec 1 dtmf-relay h245-alphanumeric no vad ! dial-peer voice 501 voip session protocol sipv2 incoming called-number . voice-class codec 1 dtmf-relay rtp-nte ! dial-peer voice 8000 pots destination-pattern 000T port 0/2/0 prefix 00 ! dial-peer voice 13 pots destination-pattern #1[0-7,9]. port 0/1/0:15 prefix #1 ! dial-peer voice 401 voip preference 9 destination-pattern 17404... session target ipv4:192.168.1.101 incoming called-number . voice-class codec 1 dtmf-relay h245-alphanumeric no vad !   Thanks    ... View more

Hi, Thanks for the reply . If I have remote destination profile activated , and then tried to forward to different number what will happen in that case Thanks ... View more

Hi, here is the conf    voice-port 1/0/0 timing hookflash-out 50 connection plar opx 8200 bearer-cap Speech ! voice-port 1/0/1 timing hookflash-out 50 connection plar opx 8333 ! voice-port 1/0/2 timing hookflash-out 50 connection plar opx 8200 ! voice-port 1/0/3 timing hookflash-out 50 connection plar opx 8201 ! voice-port 1/0:15 bearer-cap Speech ! ! no mgcp package-capability res-package no mgcp package-capability fxr-package ! ! ! dial-peer voice 1001 pots destination-pattern 001T port 1/0/1 prefix 00 ! dial-peer voice 1002 pots destination-pattern 002T port 1/0/2 prefix 00 ! dial-peer voice 1003 pots destination-pattern 003T port 1/0/3 prefix 00   Thanks  ... View more