ISE posture check with Juniper switch

[Sandy_G]

Hello Everyone,

I am facing some issue during ISE posture check with Juniper EX4300/EX4600 switches.

Can someone help with juniper switch Profile setting in ISE and configuration require on switch?

Dot1x is working fine but not posture.

[pan · Accepted solution]

You should use posture without redirection.

Check below doc:

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine-22/210523-ISE-posture-style-comparison-for-pre-and.html

[sheefu619]

hi could you please help me the config on juniper switch end for supporting posturing on ISE

thanks and regards

[Mitesh Manwatkar]

Hello All,

Recently I got an opportunity to perform POC with Cisco ISE (2.7 Patch 4) and Juniper EX 2300 switch to perform 802.1x EAP-FAST (machine + user) authentication followed by Posture Assessment on Windows 10 Machines (installed with AnyConnect 4.9 NAM , Posture and compatible compliance module)

I was able to perform all the requirements of client successfully.

Most challenging part of to achieve seamless posture assessment using dynamic URL redirect.

Attaching the document which can guide everyone to configure the same. Hope it helps.

Regards,

Mitesh Manwatkar

[irshadkal]

HI Mitesh,

Can you kindly provide the Juniper Switch commands if possible? I like your Posture Steps on ISE.