Migration of ACS to ISE

[sujanyakj]

Can we enable the migration via ACS GUI, as we not sure about the password of ACS CLI.

[balaji.bandi]

yes check step by step :

https://community.cisco.com/t5/security-documents/acs-to-ise-migration/ta-p/3644038

[sujanyakj]

I checked the above document. It says we need to enable migration by using below command via CLI.

acs config-web-interface migration enable

My requirement is to enable the migration via ACS GUI

Please help me here

[balaji.bandi]

apologies, not that i am aware that is possible... you need to password reset then, make a maintenance window and reset the password.

Hope your device has fallen back to your local account, so you should be ok to reset the ACS password. this may have been locked due to a number of attempts of wrong password entries.