releasing stuck backup via ISE CLI

[SMD28316]

From documentation, you can release stuck backup using the command app conf ise and choosing the option 24 (Force Backup Cancellation). After choosing this option, will the ISE node reload? I didn't find anything usefull in the documentation.

[Marcelo Morais · Accepted solution]

Hi @SMD28316 ,

 no, ISE don't reload.

ise/admin# application configure ise
Selection configuration option
[1]Reset M&T Session Database
[2]Rebuild M&T Unusable Indexes
...
[24]Force Backup Cancellation
...
[27]Recreate undotablespace
[0]Exit
24
Are you sure you want to proceed? y/n [n]: y
Successfully submitted request to cancel the backup process
Selection configuration option
[1]Reset M&T Session Database
[2]Rebuild M&T Unusable Indexes
...
[27]Recreate undotablespace
[0]Exit
0
ise/admin#

Hope this helps !!!