Secure Access Control Server 1112 questions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-04-2009 08:27 AM - edited 03-10-2019 04:22 PM
We have the ACS 1112 that we have never taken the time to setup until now.
I realize this is end-of-life, but we only need it to audit logins for a few local core devices and a few remote devices across the WAN.
I can't seem to find IOS upgrade for this device or any setup config info.
Any help would be appreciated.
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-04-2009 08:34 AM
This is the download link for ACS SE patches:
http://www.cisco.com/cgi-bin/tablebuild.pl/acs-soleng-3des
I suppose it all depends where you're at and where you'll like to go.
Upgrade Scenarios
If you have a software contract, the base images can be provided by TAC.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-04-2009 12:31 PM
Thank you, very much appreciated.
I inherited this thing and having a hard time finding documentation on setting it up.
It is not allowing me to console in and when I put a monitor on it and bypass the boot by hitting delete it's asking for a password? No clue what they put on it. I'm just trying to see what ver. this thing is @
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-04-2009 12:39 PM
Is it the BIOS Password?
You can find the defaults here:
Password Recovery Procedure for the Cisco Secure ACS Solution Engine
If this is not in use...you might want to format/re-image the device and start from scratch...although you need the 1112 Recovery CD.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-04-2009 12:50 PM
yes the bios although I really can get by without it right now.
The recovery cd, yes this would be what I need.
....so what is the trick to get the console port to work? Just standard 9600 baud 8bit?
-thanks
