Network Access Control

We have two ASA 5510 with version 8.2(1) in Active/Standby configuration, the failover works fine, but when the primary ASA comes back it remains standby , so we manually change it to active with the failover active command, then we try to access the...

Hi,I would like to use Cisco ACS as a Radius server to authenticate users for internet access.Am using ISA 2004 as proxy server.Could you show me, how I can configure Cisco ACS to :- Use Active Directory Database for users.- Restrict every user to on...

I'm trying to see if its possible to use ACS 5 patch 8 to authenticate WCS.Looking at the ACS 5.0 gui I'm looking at where you would enter the tacacs+ or radius custom attributes. From doing some configuration it would seem that the tacacs+ custom at...

I am having a hard time figuring out why authorization fails for users when logging into a switch/router using tacacs to ACS 4.1.123. Authentication does work and I have shell exec and priv=15 service enabled. Am I missing something else?

when I restart the ACS server, the ACS service needs to be started manually.

I recently upgraded an ACS appliance 1111 from version 3.2 to 4.1.1.24. if I power up the device it asks me to reset the administrator password and all that. After the device reboots it asks me to reset the administrator password again, it keeps on d...

Can anyone tell me if Cisco has made brackets for the ACS appliance so it can be mounted in a switch rack instead of a server rack?

Dear All, i have ACS engine based on windows.in reporting , we can see its memory decrease by about 50 MB dialy.after a week it is not responding and must be restarted physically.

Hi,I would like to know how RADIUS server works. I have a PIX 501 in which I can experiment after setting up a RADIUS server. Is there any step-by-step guide (which could be followed by a newbie)for setting up a RADIUS server?

Hi Experts,I am trying to configure/change the IP address of the ACS appliance through console port but the problem is that it is not allowing me to do when it is up and running hence i restarted it and went to bios diagnostic msgs after ACS boots up...

I am trying to find the serial number of an existing ACS installation.Does anyone know where the licence key is stored within the configuration files/registry ? Thanks

We currently run ACS 3.3 on a member server. We authenticate users to AD groups for Wireless and Network Management of hardware Devices. We upgrading to ACS version 4.2 on new hardware. From discussion on this forum it looks like we can run Windows S...