01-26-2012 12:40 PM - edited 03-12-2019 05:40 PM
Hi,
All our network devices are configured with TACACS+ with ACS 5.2; authentication, authorization & accounting is working fine. We were trying to integrate ACS with Vasco for 2 factor authentication using RADIUS. While integrating, i found that because of authorization commad enabled on the network devices, user authentication was not successfull. I removed the authorization commands from the switch & it worked.
I need authorization facility as well as 2 factor authentication. Can someone suggest me how to proceed with this plz !!!
01-26-2012 04:39 PM
Hello,
When referring to "Two Factor Authentication" are you referring to two different password prompts?
Username:
Password:
OTP Password:
Or are you referring to:
Username:
OTP Password:
Also, did you change TACACS+ for RADIUS on the AAA Client (Network Device) configuration in order for it to communicate with the ACS server?
We will be waiting for your clarification.
Best Regards.
01-27-2012 12:01 PM
Hi,
My devices are configured to support TACACS+ with ACS.
I am looking at:
Username:
Password: PIN + OTP
If I disable authorization in the switch, it works fine.
Rgds,
Partha
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide