Network Access Control

ineed to know for sure  (and with detailed official documentation links or experience if possible)if ISE for CoA accepts vlan names rather than vlan id numbers (multiple vtp domains: we have multiple vlan id numbers under the same consistant naming)t...

Dear Support TeamACS 1121 Appliance has 4 Gigabit Ethernet ports on the Rear Side, They are listed as Gigabit Ethernet 0Gigabit Ethernet 1Gigabit Ethernet As per Cisco Documentation, (See Attached Snapshot), All these ports are blocked Except Gigabit...

Hello all.I may be blind but I've not seen this topic in the documentation; I refer to "Catalyst 4500 Series Switch Software Configuration Guide, Release IOS XE 3.3.0SG and IOS 15.1(1)SG"The Sup7 has a dedicated FastEthernet port which is automatical...

Hello againOne problem is solved, but another problem has come.I use the MDA Mode. And if the radius is not available, the voice and data device will placed in the data domain.A security voliation blocked the port after: SECURITY_VIOLATION: Security ...

Hello,I have an ACS applicance that had a version 5.1 and i did an upgrade to 5.3 with latest patch.For some reason, the runtime process got stuck in (reinitializing and restarting) state.i did the recommended action to perform ACS stop and ACS start...

Hi, the customer has ACS 5.3 and it was connected with AD successfully.Now the customer has changed the DC name and ACS still refers to the old name.How to force the new DC discovery without clear all the configurations ?Without DC discovery, I have ...

Hi,Currently, i deployed a Cisco NAC Appliance with sofware version = 4.8.2. My NAC agent software version = 4.8.3.3 and Compliance Module version = 3.5.1549.2.Some machines are having the older compliance module sofware versions are like 3.5.2.5. So...

Hello,I'm working on implementing a RADIUS authentication for wireless access with the following :- PCs running Windows 7, protocol used is PEAP (without validating the server certificate to make it simple at first),- AP 1252  configured to use a RAD...

Dear All,   i have configured primary ACS in DC data center and secondary ACS in DR data center, i have configured replication , and it is working well, but when we put down primary ACS , we are unable to login in switch and router through secondary ...

I have configured IE security,NTP and DNS settings. But SSO isnt working. Is there any gotchas for NAC Guest Servr SSO?