cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1223
Views
0
Helpful
1
Replies

VLAN DHCP release on ISE

kharada
Cisco Employee
Cisco Employee

My customer tested VLAN DHCP release function, and found that it becomes an error (ui_vlan_install_error_message) when they waited for approximately 60 seconds without pressing both buttons of "Install" and "Don't Install".

[Q] Can we change this time-out value(60sec)?

Thanks,

Kazuhiro

1 Reply 1

hslai
Cisco Employee
Cisco Employee

Assuming this about NAC agent or AnyConnect ISE posture, then there are some configurable items in an agent profile. For example, below shows the parameters for Posture Agent Profile Settings:

Screen Shot 2017-02-13 at 8.37.28 AM.png