I have a stack of 3850, currently there are 3 in this stack. I would like to place a Loopback IPADDR on each of the switches in case one would drop. I currently am monitoring the main management IPADDR but when the 3 switch decided to drop a couple times this morning I was unaware.
How would I place the Lo ADDR on each switch?
Session switch 3 only provides these options:
SW01(diag)# Exec mode commands ap Global access points commands clear Clear commands codecov request cflow command copy Copy commands debug Debug commands default Set a command to its defaults disable User privilege level enable Enable privilege level license Configure license. no Negate a command or set its defaults request Request commands session Open a connection set Set commands show Show commands switch Switch related paramtes terminal Terminal parameters test test commands wireless Configure wireless parameters
There is currently only one Uplink for the connection at this moment. They is no failover.
The 3rd switch in the stack had been dropping but in PRTG, I was not able to see the individual switch statues. I was looking to place an IPADDR on the switch in order to setup pings to be noticed when they failed. The logging is not producing why they are failing, but wanted to be proactive without the users reporting the connection was down for them.