Hey guys, I have a small home network, where i would like to sent multicast (239.1.1.1) from Router 1 (Cisco 892FSP-K9, IOS 15.2) to Router 2 where Router 1 has PIM-DENSE Mode set. I would like to secure Router 1's network so no one can get into Rout...
Forum Posts
Hi, I'm wondering how to get the MAC Address Table using SNMP on ASR920 routers. Is there any MIB similar the ones used for Catalyst Switches? e.g. BRIDGE-MIB and dot1dTpFdb Object-Type?
Hi All, My Cisco prime license reports indicates that I have about 45 token available, however when I tried to add device it says that there are no licenses available. Is this an expected behaviour? Regards, Kanes.R
Hello , TeamThe XXX.XXX.2.XXX bandwith is divided into 1-127 and 128-254.A server ip - XXX.XXX.2.139.The B server has two IPs. (one- VIP:XXX.XXX.2.32 , Real IP-XXX.XXX.2.141)-A server can connect ssh and sftp to B server Real IP.-Within the local L4 ...
Hi AllI have a question about setting up user accounts on a Cisco router. I have seen a statement like the following on a Cisco router username cisco privilege 15 secret 5 $1$s4bl$Lb.b/v/HgWKTdfP/h9However if I try and enter the command "username <my...
Hi, I have two cisco wsa S690 v11.5 which always monitor the proxy cpu usage (due to the great quantity of connections per second since a couple of times we received slowness). Today I was very surprised since one of the WSA reported 156.7% of proxy ...
Hello I have Cisco router 2951(IOS 15.0) and Microfocus NNMi monitoring system. Router is discovered by NNMi and configured to monitor interfaces properly. Actually it is working when NNMI requests NNMi traps (with 5m interval). And when some interfa...
Hoping someone can help me here as i been unable to figure this out.I have a command "sh ip cache flow | in 0000" that I need to append to a file on flash.However when i use action 1.6 cli command "sh ip cache flow | in 0000 | append disk0:/rxload.tx...
Resolved! Static NAT understanding
Hi, I am just trying to understand better how does the NAT work and I have problem to understand the topology below. The question which I have is: why the link between firewall and the router is using public address, rather then private ? The router ...
Hi Guy Configuring following: line vty 0 4 transport input all password Pass1 login I' m able to access using telnet but using an ssh client it doens't work. It seems "username " is needed. So is there a "default username" that IOS associate to...
Hi,So I need some help configuring a Cisco 1811W router. I've been out of the CLI game for several years and have forgotten a lot of the detailed config commands and how it all works. So below I'll detail what I need, but first I really just need a...
Hello, Is there any way to monitor CAT 3650 stack ports via SNMP ? BR, AK
Hi everyone, I'm trying to perform snmp get operations on an ASR920, more precisely on the VRRP. But I've found out that while in other routers (ASR 1001-X, ISR 1100, etc...) the oid 1.3.6.1.2.1.68 works well (VRRP-MIB ), on the ASR 920 it doesnt'....
