11-23-2009 01:30 AM
Hello,
I tried to add ASA IPS module to LMS CS, but LMS can not recognize it, show it as unknown device, i tried to SNMP WALK this device, it is successful, so i manully change the device type to
Cisco ASA Advanced Inspection and Prevention (AIP) Security Services Module, and i can get the correct icon theen,
but i tried to use RME to archive config, it failed, and tried to create HUM poller to monitor CPU and memory utinization,
but no such instance template. could anyone tell me the LMS support ASA AIP module or not? thanks.
11-23-2009 07:44 AM
What is the sysObjectID of this device?
01-06-2010 10:31 AM
RFC1213-MIB::sysObjectID.0 = OID: CISCO-PRODUCTS-MIB::ciscoIPSSSM10
.1.3.6.1.2.1.1.2.0 = OID: .1.3.6.1.4.1.9.1.662
I can't backup a config in RME, gives the errors:
SSH: Failed to establish SSH connection to x.x.x.x - Cause: close() called twice.
SSH: Failed to establish SSH connection to x.x.x.x - Cause: Authentication failed on device 3 times
but I know the password is correct
01-06-2010 10:38 AM
This device is not yet supported by RME. I have requested support, but there is currently no ETA.
01-03-2013 12:52 PM
Is not yet supported by the module aip ssm module on lms 4.2 for archive configuration ? Thanks a lot
01-04-2013 01:03 PM
No, this device is not supported by LMS config archive.
01-05-2013 11:00 AM
Thank you for your answer but is there a list of device supported ?
Thanks a lot
Emiliano
01-05-2013 04:48 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide