05-02-2006 01:50 PM
hi
I need know like is consumption the bandwidth link by application (http, ftp, smtp) in a router with C2801-ADVIPSERVICESK9-M IOS
I enable in the router nbar protocol-discovery but it does not indicate the consumption in percentage on the bandwidth during a certain period of time
05-02-2006 02:35 PM
If the router have the NM-NAM installed, that can help with this as well.
05-03-2006 07:51 AM
hi rmushtaq
I don't have the NM-NAM, I need know if is possible only with IOS or any software
05-04-2006 03:31 AM
To enable you need "ip nbar protocol-discovery" on the interface and (I think) "ip cef" global command.
Then
"show ip nbar protocol-discovery interface
should show you an actual bitrate. If you need a percentage divide the bitrate shown by the max bandwidth available on the interface. Also I think that the reporting period can be controlled with the "load-interval" interface config command - default is 5 minutes but can go as low as 30secs
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: