Hi, has anyone used BQM v3 in anger?
I'm tring to install one using switch Span ports / without passive taps.
The device seems to work but only "sees" local traffic and not remote site traffic(remote sites are over MPLS N/W and are all configured within BQM).
If I configure the local sites subnets within BQM then it shows no traffic at all!
I guess what I'm really looking for is a fundamental guide to how this device should work.
Take a look at this link.
Thanks for your response, unfortuantly I have already read that doc.
I still haven't met anyone who's used BQM - I'm guessing that this is one of those products that few people bought!