03-12-2013 10:50 AM
Hello,
Is there a way to apply the same command (i.e. logging host <LMS_IP_address>) to a big number of devices?
If not in LMS, is there any other option?
Thank you,
Justine.
Solved! Go to Solution.
03-12-2013 12:13 PM
Sure, netconfig is designed for just this task. There's even a pre-defined template for the "logging host" setup.
Please refer to this section of the Configuration Management guide for complete instructions.
03-12-2013 12:13 PM
Sure, netconfig is designed for just this task. There's even a pre-defined template for the "logging host" setup.
Please refer to this section of the Configuration Management guide for complete instructions.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide