cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
300
Views
0
Helpful
1
Replies
Beginner

Can't connect to new router 2900 via console cable.

hi,

I can't connect to my newly purchased router 2900 using serial cable and it has no display on the terminal? before console i working fine but today its'not working.

Note: telnet is working.

I Tried the Following.

Change new workstation for testing, Console cable, terminal, use usb-serial & change baud rate but the result is same it's blank.

also verify line console 0 run all configuration.

line con 0
 motd-banner
 exec-banner
 exec-timeout 10 0
 timeout login response 30
 privilege level 1
 password 7 0706354F
 flush-at-activation
 logout-warning 20
 absolute-timeout 0
 login
 modem answer-timeout 15
 modem dtr-delay 5
 data-character-bits 8
 exec-character-bits 7
 special-character-bits 7
 domain-lookup
 exec
 length 24
 width 80
 history size 20
 history
  editing
 monitor
 escape-character soft DEFAULT
 escape-character DEFAULT
 autohangup session-timeout
 ip netmask-format bit-count
 ip tcp input-coalesce-threshold 20
 databits 8
 stopbits 2
 start-character 17
 stop-character 19
 speed 9600

 

please see the attached photo.

any suggestion? 

thanks

Everyone's tags (1)
1 REPLY 1
Highlighted
Cisco Employee

Please ensure that you have

Please ensure that you have correctly configured your terminal emulator settings properly. The default settings can be found here. 

 

http://www.cisco.com/c/en/us/support/docs/dial-access/asynchronous-connections/9321-terminal-settings.html

 

Edit: Also if you are attempting to use this on a device without a native DB-9 (Serial) port, and are using a USB to Serial convertor, then this may also be causing your problems, without further information I cannot help any further. 

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards


This widget could not be displayed.