cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1667
Views
0
Helpful
6
Replies

cannot access or ping from computer catalyst 9200

R1nzler
Beginner
Beginner

Hello all,

 

i've configured my new cisco switch 9200

i've put the fibre port in trunk mode, allow all vlans, etc.

in the 3750x i can ping it and from all 2960s/x i can ping it to

 

however when i try to ssh or use the webgui it says "connection time out" and nothing happen and "connection timeout" in putty

 

cant seem to find whats missing

6 Replies 6

Seb Rupik
VIP Advisor VIP Advisor
VIP Advisor

Hi there,

Is the netmask on the management interface correct?

Does it have a default route configured?

 

cheers,

Seb.

R1nzler
Beginner
Beginner

@Seb Rupik 

i configured in the management vlan the ip and netmask.

if i assign the management vlan to a port and connect a cable there to a pc with the same IP i can access the webgui and ssh
however if i connect only the switch with the fibre cable in trunk i cannot access webgui or ssh

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend