cannot getting response from ssh -vrf command i can ping other side and ip address has been added to access-list

[zeeshanmoon77]

we are creating new tunnel and wants to keep customer routing table sprt.  i have created MGMT tunnel using vrf and loopback interface for management. currently i am using interface loop-back 0 from globe routing table for mgmt and its working. new DMVPN tunnel for mgmt is up and i can ping but when i use ssh -vrf command i am getting no responded from host. MGMT vrf ip address has been added in access-list for vty. cannot understand the problem please advise.

regs

[Spooster IT Services]

Hi,

Below is the link which will guide you for vrf aware ssh/telnet.
https://www.cisco.com/c/en/us/support/docs/ip/telnet/200718-Configure-Telnet-SSH-Access-to-Device-wi.html
If you still have issue, Please provide the output of the error and "show run | sec line".