09-28-2023 02:15 AM
I'm quite new to Network administration so excuse the very basic newbie question.
I'm trying to get SSH working on CBS350-24T-4X and CBS350-8XT devices but it just doesn't work and I'm not even sure why that is. I'm working with the CLI through a terminal cable using MobaXterm.The goal would be to remotely access the switches through SSH for administration purposes.
Is there a step by step guide or video or am I just going at this completely wrong?
09-28-2023 02:31 AM
Hello!
Try enabling it over GUI:
09-28-2023 02:46 AM
check this config guide :
09-28-2023 02:51 AM
thank you very much @balaji.bandi and @DanielP211
I've seen that Video which is for older switches not the CBS350, isn't there a way of doing it with the CLI?
I have 13 switches to set up and there's more to come so going in through the webGUI will take a lot of time, I was hoping fopr something I could maybe even work into the config files.
09-28-2023 05:42 AM
I'm not aware about any guide for it, but just to enable the SSH service type:
MSW3#configure
MSW3#ip ssh server
You can, of course, type "ip ssh ?" to see all options.
09-28-2023 06:50 AM
after a bit of back and forth I added this to the cfg:
the last line is because of:
09-28-2023 09:38 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide