02-09-2013 05:56 AM
Hi All,
We are using Cisco 1941 Router as CPE where we wanted to trap CPU, Memory & ISYSTEM MIB.
The same we are achiveing using SNMPV2 but when we tried using SNMPV3, there is no response for these MIBs.
We tried to configure SNMPV3 using below Link but still there was issue. There was response fr
Wanetd to know SNMPV3 MIB are supported for Cisco 1941 Router IOS Code universalk 15.2(3)T1 & Data License.
When we tried using Cisco IOS MIB Locator, we are not able to see any MIB for SNMPV3. whats is that mean. Does this Platform + IOS Support SNMPV3 or not.
Below is the Snapshot from Cisco IOS MIB Locator for said image.
NMP-COMMUNITY-MIB | V1 | V2 | |
SNMP-FRAMEWORK-MIB | V1 | V2 | |
SNMP-MPD-MIB | V1 | V2 | |
SNMP-NOTIFICATION-MIB | V1 | V2 | |
SNMP-PROXY-MIB | Note | ||
SNMP-TARGET-MIB | V1 | V2 | |
SNMP-USM-MIB | V1 | V2 | |
SNMP-VIEW-BASED-ACM-MIB | |||
SNMPv2-MIB | V1 | V2 | |
SNMPv2-SMI |
Regards,
YSR.
02-11-2013 12:24 AM
Wrong forum, try "network management'. You can move your post using the actions panel on the right.
02-11-2013 10:41 AM
Hi Sir,i think Snmpv3 cant install on this ios router
Sent from Cisco Technical Support iPad App
02-11-2013 01:19 PM
YSR
The 1900 router certainly does support SNMPv3.
HTH
Rick
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide