Network Management

Hi all,I added this wlc in lms   and tried to collect inventory. But it is failing after taking long hours.(LMS Version 3.2.1,WLC 4404 -Version 7.0.116)(SNMP walk is successful & using SNMP V2c)I hope the specific package is available in LMS as i cou...

Hello,I am deploying 4g hwics for remote locations. The 4g hwics work well most of the time.  However I am seeing one issue that i'm hoping can be addressed using a script.  We have 4g hwics that connect to the LTE netwwork.  However at times it drop...

Hi,I have been struggling to find a DDNS provider from which the IP address can be updated from a Cisco device.One does not seem to support it, (Free-DDNS) other must be paid for (No-IP.org) while the free version does not update the IP address in my...

we've just installed the ncs.  i understand this tool can even shine my shoes, but i'm looking for how to do something very simple.how can i get traffic graphs of a specified switch port?tnxams

Hi.how to configure two interfaces giga in the same vlan (1)?thanks

Hello guys,I am working in a company where we have thousands of devices with poor OOB Management. We were using MRVs but their support is poor and not meaningful. Could some-one know about any new device or vendor that deploy OOB which is cheap and g...

I have this script which I'm trying to collect snmp stack based on the %SNMP-3-INPUT_QFULL_ERR. But my concerns is that when these error starts they run for about 2 hours and I get thousands of syslog entries for this error. I want to be able to limi...

Hello everyone, I've been having troubles with the cpu utilization. There's the output of the command show process cpu | ex 0.00CPU utilization for five seconds: 98%/4%; one minute:   72%; five minutes: 68%PIDRuntime(ms)InvokeduSecs5Sec1Min5MinTTYPro...

Hi,I am trying to plan a design for multiple sites/zones for Cisco prime LMS. The scenario I have is as follows:1. There are a total of 5 different buildings/zones. Do note this is within the same location however divided into multiple blocks/buildin...

HelloI have installed the new version of DCNM Prime (Version: 6.2(1) and all installation process went well without any error or warning, DCNM SAN client works well I can loggin and manage my MDS and UCS, but I have big issue to run DCNM LAN client a...

Hello,I have been tasked to write a TCL script which will run every 30 days and send out the information below:   sh ver   sh Inv   sh run   sh configUnfortunately a good pile of our routers will not have access to a TFTP server for security reasons ...

Hi,We have a C4948E switch which is generating the following logs every ten minutes:May 28 12:44:13 UTC: %SEC_LOGIN-4-LOGIN_FAILED: Login failed [user: Username: -40.0] [Source: 0.0.0.0] [localport: 0] [Reason: Login Authentication Failed] at 12:44:1...